trex signature railing post cap lighting

TREX SIGNATURE RAILING POST CAP LIGHTING INSTALL
TREX SIGNATURE RAILING POST CAP LIGHTING MANUAL
TREX SIGNATURE RAILING POST CAP LIGHTING WINDOWS

Again, use a circular saw with a fine blade to make all four cuts. Transfer the mark to its new location with your speed square for accuracy. Move each cutting mark ¼ inch in to accommodate bracket size. Cutting at this angle will help you to avoid running into the rails as you cut. Straighten the panel out before cutting so the rails are running away from you directly at 90 degrees, then clamp. Take your stair railing over to your sawhorse to cut. Step Four: Cut Your Trex Signature Stair Panel to Size Repeat at all four meeting points of post/rail. To do this, use a pencil to record where the bottom of the rail intersects your post. When your spacing is correct, mark the location for your brackets on your posts. Remember to measure at a right angle to posts, not at the angle of the stairs and railing. Step Two: Clamp and Mark Your Trex Stair PanelsĬlamp and mark your panels, making sure the space between the post and the closest baluster is equal on both sides. Look for even spacing between the baluster and post on both ends, and make sure your balusters are running parallel with your posts. Place your railing section on top of your scrap decking board and adjust to work out the correct placement. This will be your platform for marking and will help you determine the correct bracket height.įrom here, you can determine what angle your stair panels need to sit at. Mark and cut it to fit snugly between your posts, running along the nose of your stairs.

To begin properly racking your stair panels, locate a piece of scrap decking. This is why there are no pre-mounted brackets on stair posts - the angle determines the necessary bracket height. Racking means changing the angle of your railing panels to accommodate the angle of your stairs. Step One: Racking Trex Signature Stair Panels

TREX SIGNATURE RAILING POST CAP LIGHTING INSTALL

They do, however, need to be racked, the cutting can be a little more complex, and you have to install the brackets on the posts. Trex Signature stair panels are installed in a very similar way to horizontal panels. Simply set it on top of your post, make sure it's aligned and level, and tap into place with your mallet.

TREX SIGNATURE RAILING POST CAP LIGHTING MANUAL

Set these in place, and use a piece of wood to tap them into place as the space between balusters is too small for a mallet or much manual dexterity. The bottom bracket covers are more rigid, with a tab at the post side. The top covers are flexible - just press and click them into place over the top of your bracket. You should hear the top cap click into place, but you can test it by pulling along both edges. Measure it, mark it, and cut it before you set it on top of the rail, align the ends, and tap it into place with your rubber mallet. The top cap – which goes over the top rail – has to be the same length as that rail. Step Four: Installing the Top Cap, Bracket Covers, and Post Caps Otherwise, you risk damaging the thread on your screws or the top rail and bracket. Remember to adjust your drill to a lower setting to insert the screws. Next, secure the top rail to the brackets on the railings at both ends with the provided stainless steel screws.

TREX SIGNATURE RAILING POST CAP LIGHTING WINDOWS

Once they're sitting comfortably, use the windows you cut in the anti-rattle strip to drill two holes through the rail and the bracket. Next, line the ends of your railing up with the brackets on your posts and set them into place. Start this step by placing your anti-rattle adhesive strip on the top surfaces of your two bottom brackets. You'll have to backtrack later if you don't cut them now. This is to allow you to fasten your railing to your brackets and posts. Finally, you need to cut access holes in the anti-rattle strip at the top of your railing.

Trex signature railing post cap lighting